Juno-Electrolux JUG94885 Manual do Utilizador descarregar pdf (Página 32)

32

electrolux

MAINTENANCE

Unplug tthe aappliance bbefore

carrying oout aany mmaintenance

operation.

Warning

This appliance contains hydrocarbons

in its cooling unit; maintenance and

recharging must therefore only be

carried out by authorized technicians.

Periodic cleaning

Clean the inside with warm water

and bicarbonate of soda.

Rinse and dry thoroughly.

Do nnot ppull, mmove oor ddamage

any ppipes aand //or ccables iinside

the ccabinet ..

Clean the condenser (black grill)

and the compressor at the back of the

appliance with a brush or a vacuum

cleaner. This operation will improve the

performance of the appliance and save

electricity consumption.

Many pproprietary kkitchen ssurface

cleaners ccontain cchemicals tthat ccan

attack/damage tthe pplastics uused iin tthis

appliance. FFor tthis rreason iit iis

recommended tthat tthe oouter ccasing oof

this aappliance iis oonly ccleaned wwith

warm wwater wwith aa llittle wwashing-uup

liquid aadded.

Periods of non-operation

When the appliance is not in use

for long periods, take the

following precautions:

remove the plug from the wall socket;

remove all food;

defrost and clean the interior and all

accessories;

leave the door ajar to allow air to

circulate to prevent unpleasant smells.

Remove the protection (A) by

unscrewing both screws (B).

Clean the protection and the bottom of

the compartment.

After cleaning replace the protection

and fix with both screws.

Defrosting

The freezer compartment, however,

will become progressively covered with

frost. This should be removed with the

special plastic scraper provided,

whenever the thickness of the frost

exceeds 4 mm. During this operation it

is not necessary to switch off the

power supply or to remove the

foodstuffs.

Never uuse ssharp mmetal ttools tto

scrape ooff ffrost ffrom tthe eevaporator aas

you ccould ddamage iit.

However, when the ice becomes

very thick on the inner liner, complete

defrosting should be carried out as

follows:

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Comentários a estes Manuais

Sem comentários