Installation instructions
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.)
Installation may only be carried out by a quali-
fied electrician. The minimum distances to
other appliances and units are to be ob-
served.
Anti-shock protection must be provided by
the installation, for example drawers may on-
ly be installed with a protective floor directly
underneath the appliance. The cut surfaces
of the worktop are to be protected against
moisture using a suitable sealant.
The sealant seals the appliance to the work
top with no gap. When building in, protect the
underside of the appliance from steam and
moisture, e.g. from a dishwasher or oven.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
Warning! Risk of injury from electrical
current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing
correctly.
• The appliance must be connected to the
electrical supply by a qualified electrician.
• Loose and inappropriate plug and socket
connections can make the terminal over-
heat.
• Have the clamping connections correctly
installed by a qualified electrician.
• Use strain relief clamp on cable.
• In the event of single-phase or two-phase
connection, the appropriate mains cable
of type H05BB-F Tmax 90°C (or higher)
must be used.
• If this appliance’s mains cable is damaged,
it must be replaced by a special cable (type
H05BB-F Tmax 90°C; or higher).The latter
is available from the Customer Care De-
partment.
A device must be provided in the electrical
installation which allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm
Suitable isolation devices include line pro-
tecting cut-outs, fuses (screw type fuses are
to be removed from the holder), earth leak-
age trips and contactors.
Sticking the seal in the rabbet
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive sealing
tape supplied onto the upper surface of
the rabbet along the edges of the cut-out
section.
– Cut the sealing tape into four pieces re-
lating to the length of the edges of the
rabbet.
– For the four corners of the rabbet the
ends of the sealing tapes must be cut
into mitres. Do not stick the ends over
one another.
– Stick the sealing tape flush into the cor-
ner of the rabbet, so that no silicon com-
pound can get under the glass ceramic
when grouting.
– Don’t stretch the tapes when sticking
them on.
14 electrolux
(16 páginas)
(16 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais